This EAL 2 Day Course is for those who wish to become a domestic or commercial EV charging Installer. Highly Experienced Tutors
16 November2 days, 09:00 AM - 04:00 PM
04 December2 days, 09:30 AM - 04:30 PM
05 February2 days, 09:30 AM - 04:30 PM
04 April2 days, 09:00 AM - 04:00 PM
23 May2 days, 09:00 AM - 04:00 PM
28 May2 days, 09:30 AM - 04:30 PM
22 July2 days, 09:30 AM - 04:30 PM
05 September2 days, 09:00 AM - 04:00 PM
24 October2 days, 09:00 AM - 04:00 PM
11 November2 days, 09:30 AM - 04:30 PM
This qualification aims to provide expert guidance to learners wishing to gain knowledge and understanding on Electric Vehicle charging equipment installation.
This 2 day course provides expert guidance on EV charging equipment installation, an important emerging area which is not covered in detail by the current edition of the Wiring Regulations (BS 7671) or the IET’s Guidance Notes.
Aimed at experienced electricians interested in understanding a wide range of equipment and systems available, this course applies to the specialised installation requirements of electric vehicle charging equipment in domestic dwellings, on-street locations, commercial and industrial premises.
The course provides detailed guidance and recommendations on all aspects of the installation of Electric Vehicle Charging Equipment from the origin of the electrical supply, through distribution and final circuits, installation of the charging equipment itself to the cable between the charging equipment and vehicle’s electrical inlet. Also included are related issues of site layout and planning and subsequent inspection, testing, certification and maintenance of installations.
Why take this course?
Currently there is an increasing demand for new electric vehicle charging points but too few installers to roll them out. This is already a booming market which is due to get much bigger in the near future. The number of public charging connectors and locations has increased by 38% in the past 12 months and is expected to continue at that rate for years to come.
There are no formal entry requirements for this qualification, however we do expect you to meet the following requirements:
- Minimum age 18 years old (mandatory)
Must be able to demonstrate the following competencies
- Be able to correctly install and terminate:
- pvc/pvc cable (twin and earth)
- Steel Wire armoured cable (swa)
- Be able to carry out an initial verification (inspection & testing) on an electrical installation and complete the necessary paperwork.
Please Note: These competencies are required for the assessment and are not taught as part of the course. It is also recommended that you are up to date with your wiring regulations.